Maytag washers are built to last, but a washer full of water is still a bad day. Many Maytag models share parts and designs with Whirlpool, so the causes are similar. Here is where to look first.
Most Maytag front-load washers have a small access panel at the bottom front. Behind it is a filter that traps coins, buttons, hair ties and lint. Drain the water through the small hose if your model has one, then remove, clean and reinstall the filter hand-tight.
Check the drain hose on the back of the washer. It is easy to pinch when the washer is pushed back against the wall. Make sure the end is not clogged and is not pushed too far down into the standpipe.
Maytag Bravos, Centennial and front-load models will not drain and spin unless the control confirms the lid or door is locked. A blinking lid lock light, or a washer that stops right before spin, points to the lid lock, door lock or its wiring.
A humming sound with no water moving usually means something is stuck in the pump or the pump has failed. Silence during the drain cycle can also mean the pump is not getting power.
Many newer Maytag models show F9 E1 when the washer takes too long to drain. Write down exactly what the display shows before you call. Codes vary by model, so check your owner’s manual.
If the filter and hose are clear and the washer still will not drain, or the same code keeps coming back, a part needs to be tested. Guessing and buying parts often costs more than the repair.
San Antonio Appliance Repair, LLC has been repairing appliances in San Antonio and the surrounding areas since 2006. Every part we install comes with a 1-year parts warranty. Call (210) 374-5977 or book a repair online. Learn more about our washer repair service.